Tab Gear SASR: Adjustable Suppressor Cover

$68.00
(No reviews yet) Write a Review

Tab Gear SASR Suppressor Anti Mirage Shield

Aid in preventing mirage from your suppressor interfering with your optical image and the averse affects on accuracy as a result.

Protects you, your can, and your equipment. Designed to prevent mirage from obscuring your site picture after multiple shots. Eliminating mirage is accomplished by the use of insulating materials - your can heats up, but the SASR stays cool. The outer shell of the the TAB SASR will not heat up as much so your equipment and person will not become damaged with accidental or intentional contact. Removal and handling of your can, while inside the TAB SASR, immediately after firing is possible due to the high quality insulating materials used in the construction. 

Features:

Sewn with NOMEX Thread 1000 Denier Cordura Outer Shell. Inner shell can withstand 1800 degrees Fahrenheit. There are several improved design features incorporated into the new SASR model. There really is no front or rear on the SASR cover, it can be installed in either direction and work equally well, and can be installed on the can with the can already installed on the weapon. The TAB GEAR SASR cover can slide either to the rear or off of the front of the can to allow cooling. Since the SASR cover has no built in recoil ridge at the rear to prevent the cover from sliding forward under recoil the user MUST engage either the velcro strap, or the bungee, whichever model he has, to prevent the cover from sliding forward under recoil and being shot down range.

ADDITIONAL INFORMATION:

WARNING! Since the SASR cover has no built-in recoil ridge at the rear to prevent the cover from sliding forward under recoil the user MUST engage either the velcro strap, or the bungee, whichever model he has, to prevent the cover from sliding forward under recoil and being shot down range. Either retention method works very very well and there really should be no valid reason for either model to be shot down range. My recommendation would be to tighten the retention device down and shoot a few rounds while observing the reaction of the cover. If it's moving slightly, tighten it down a little more. if it's not moving, loosen it slightly until you do see it start to move, then tighten it back a bit. That will tell you how tight you need to have the cover.